Air Cleaners
AVO Dampers
Bafled Sumps
Bearings
Bellhousings
Block Bolts
Brackets/Mountings
Cam Followers
Camshafts
Carbs and Injection
Cobra Seats
Con-Rods
Cooling accessories
Crankshafts
Cylinder Block
Cylinder Heads
Electrical
Engine Pulley's
Exhaust Manifolds
Flywheel/Clutch
Gaskets/Seals
Gearboxes
Inlet Manifolds
Long Engines
Miscellaneous
Oil/Lubrication
Pistons/Rings
Short Motors
Stroker Crank Kits
Suspension
Turnkey Engines
Valves/Timing
Water Pumps
Home > Gaskets/Seals
You're viewing 1 - 25 of 35 products in this category
Full Engine Gaskets/Seal Kit 3.5 inc. RR & SD1
Gasket and seals including Tin cylinder head x2
Sump,timing cover,water pump, valve stem seals, cruciform seals, crank orange main seal, front oil seal, Composite Intake manifold gasket + rubber end seals,rocker cover gaskets.
And now with the later big bore composite stainless steel exhaust manif......
more >>
Tin Head Gaskets 3.5
Tin shim gaskets for all 3.5 litre V8 engines.

Approx thickness 20 thou 0.5mm
more >>
Tin Head Gaskets 3.9
Tin Cylinder Head Gasket to suit 94mm Bore
3.9
4.2
4.0
4.6
more >>
Composite Head Gaskets 3.5 (pair)
Later spec composite gaskets allow better sealing between head and block face. Allow approx 1.2cc compressed thickness when calaculating comp ratio
more >>
Composite Head Gaskets 3.9 -(1.2cc)
more >>
Composite Valley Gasket
Composite Gaskets offer superior sealing quality over the older design tin item.

Suitable for all Rover V8 Engines and derivatives
Rover P5B/P6
MGBV8
Triumph TR8
Rover SD1
Range Rover = All
Land Rover Discovery 3.5,3.8,4.0
TVR 350/390 Chimera, Griffith
Morgan + 8 - 3.5,3.9,4.6

Use with......
more >>
Rear Rope Oil Seal Kit
Oil Seal Kit for P5,P6 and some early Range Rover engines
more >>
Timing Cover Oil SealSD1 >
Sd1 front cover or Range Rover Cover - 1 piece seal
more >>
Cruciform "T" seals
Fit SD1 engine > - Number 5 bearing Cap
more >>
Inlet Manifold End Seals TVR, Morgan, Rover V8
Rubber End seals fit beneath steel locating brackets.
OEM Quality
more >>
Sump Gasket (Oil)
Cork Sump Gasket for all Steel Sumps.

Use thin layer of silicone on either side of gaskets and torque to manufacturers recommedned torque values for an oil tight seal.
more >>
Timing Cover Gasket
Fits between Engine block & timing cover Chest

To suit all engines except later 4.0 & 4.6 litre Serpentine covers.

Applications :
MGB V8
Morgan + 8
Rover SD1
Rover P5B/P6
Range Rover 3.5,3.9,4.2 Non Serp
Land Rover Defender
Land Rover Discovery
more >>
Rocker Cover Gaskets
OE Cork suit early/late engines
more >>
Valve Stem Seals (rubber Washer Type)
Rubber Seals SD1 engine and > Can be used on p5 & P6 engines

To assist with oil control consider using seals on both inlet and exhuast valves. Two sets will be required if carrying out this upgrade.
more >>
Composite 4.0/4.6 Cylinder head gaskets
Late Type to suit 28 cc heads or those with 10 head bolt pattern.

These are Elring brand (OEM) and good quality.
more >>
94mm Copper Head Gaskets
1mm compressed thickness. Perfect solution for High Comp Motors where gasket failure is a problem.

For best results also consider installing ARP Cylinder Head stud Kit.
more >>
Rubber Rocker Cover Gaskets
Better sealing and re-usable -illiminate those orrible rocker cover oil leaks once and for all !

To Suit all Rover V8 Engines

Rover P5b, P6, SD1
MGB V8 MGRV8
TVR 3.5 - 5.0
Land Rover 3.5,3.9,4.0
Range Rover 3.5,3.9,4.0,4.2 & 4.6
more >>
Bottom End gasket set 3.5,3.9,4.2
Includes Sump Gasket
Cruiciform seals x 2
Rear Oil Seal (rope)
Crankshaft Main Neoprene Oil Seal ( Orange)
Timing Cover Gasket
Range Rover water pump gasket
SD1/P6 Water Pump Gasket
Oil Pump Gasket
Oil Pick Up Pipe Gasket
more >>
Rear Crank Oil Seal TVR, Morgan, Rover V8 1976 >
Suits SD1 1976 > later engines
3.5
3.9
4.2
4.3
4.5
5.0
5.2
more >>
Chevy Rocker Cover Gaskets
To be used with the Chevy Edelbrock Rocker Covers.

Also see Edelbrock Elite Rocker Covers for custom applications
more >>
Range Rover, Discovery 2 GEMS/MEMS Timing Cover Gasket
Timing Cover Gasket for approx 1995 > 4.0 and 4.6 Litre engines.

Discovery 2 4.0 Litre
Range Rover P38a 4.0 & 4.6 Litre

The above vehicles use a distributor less timing cover housing whereas earlier vehicles use a distributor fitted to the timing cover.
more >>
3.5 Composite Head Gaskets
3.5 Litre Composite Head Gaskets. OE Spec similar quality to the felpro brand but less expensive.
more >>
Range Rover Classic Water Pump Gasket
Range Rover Classic Water Pump Gasket
3.5 Carb & Efi
3.9 & 4.2 Efi
Discovery 1
more >>
Water Pump Gasket SD1, P5B, P6, MGB etc
Water Pump Gasket to suit :

Rover SD1
Rover P5B & P6
MGB V8
Triumph TR8
Morgan + 8 > 1994 approx.
more >>
Water Pump Gasket 4.0 & 4.6 Engines
Water Pump Gasket to Suit:

Discovery 1 3.9 1994 - 1996
Discovery 2 4.0 1998 >
Range Rover P38 1995 - 2002
TVR Chimera 1995 >
TVR Griffith 1995 >
Morgan + 8 1995 >

All Engine fitted with either Intermediate Timing Cover ( Lucas Dissy) Engines Equiped with GEMS or MEMS Engine Management
more >>
© Abbey Sportcars Ltd.   |   Company No. 03916786   |   VAT No. 858100630   |